Primo brew temp

[Bobertson]

Hi

What temperature is primo (methenolone enanthate) brewed at?

I have a vial from a verified source at 150 mg/ml in gso that started off pip free for a few weeks, but as I work through it is now giving me massive pip. I want to try heating it up to see if maybe it has started crashing and that is why. my test from the same shipment came crashed due to arriving in winter. I know test can tolerate high temperatures, so I put it in 150 degree water for a while which redissolved it.

How high can I go on primo without degrading it significantly?

 

[bang09]

I had the same problem as you, test cyp breaks over time and the primo has a terrible pip at 100mg or 150mg, my shipment was from October/24

 

[Sector]

Primo fucked me up too. The coffee mug warmer thing helped a bit but it still knotted me up really bad (200mg/ml)

Just ended up dropping the primo. The inflammation was worse than DHB. Idk.

 

[Chem81]

Hi

What temperature is primo (methenolone enanthate) brewed at?

I have a vial from a verified source at 150 mg/ml in gso that started off pip free for a few weeks, but as I work through it is now giving me massive pip. I want to try heating it up to see if maybe it has started crashing and that is why. my test from the same shipment came crashed due to arriving in winter. I know test can tolerate high temperatures, so I put it in 150 degree water for a while which redissolved it.

How high can I go on primo without degrading it significantly?

Assuming this source name starts with S. You can warm primo up without degrading. Remember the hormone is already in solution, just warm it up for like 5mins or so and good to go.

 

[Bobertson]

Assuming this source name starts with S. You can warm primo up without degrading. Remember the hormone is already in solution, just warm it up for like 5mins or so and good to go.

You are correct on the source.
How hot can I get it? I’d like to get it as hot as possible to help prevent any recrystalization.

 

[Chem81]

You are correct on the source.
How hot can I get it? I’d like to get it as hot as possible to help prevent any recrystalization.

You don’t really need a lot brother, bring it to 120F FOR 5mins then reduce heat and good to go