Accurate syringe measurements

[FrancoC]

Disclaimer that I’m overthinking this but just want to get other’s practices on what they do for this type of situation.

Been doing E3D injections during blast and dosages have been in full CC/mL so quite easy there. I’m about to begin a cruise of 200mg/week Test Cyp EOD for blood level stability and help with E2 levels. Problem is that makes the dosing 50mg/shot and the 3cc syringes I have make it difficult to accurately measure for 50mg as that’s half of .5cc and the line markers are 5 in total to get to .5cc. I guess somehow try to manage filling it to the halfway point of the 2nd and 3rd line?

 

[Greenbay68]

I use 1mL insulin syringes

 

[Hypertrophy]

You can use a 1ml/ 31g insulin syringe and inject .5ml subcutaneously or like above op mentioned, 1ml insulin syringes and use your own pin.

 

[acetate_jake]

insulin syringes have no "dead space"

but a 1ml syringe with a slip on needle is what I use.

a very miniscule amount of the oil is left in the needle head but nothing to think twice about

I believe as long as you measure out ur dose in the syringe and push it all through then you are getting all the oil u measured out

 

[Thrasymachus]

Insulin syringes are what I use as well.

The smaller the syringe the more accurate.

1ml, 0.5ml, there are even 0.3ml if I'm not mistaken as I've read of females using these to dose with short ester to keep from using too much.

The bad thing about smaller syringes is that the plunger can flex, where's a 3ml syringe has a very stiff plunger that makes injecting easier if pinning in awkward locations.