BPC-157 and TB-500 combo, tips?

[rastaman69]

I've not used these peptides before. I have become quite used to running multiple anabolic steroids at the same time and have a technique down for drawing multiple compounds into one syringe.

In order to cut down on the number of injections, is it advisable to do a similar thing with BPC-157 and TB-500? I want to start this treatment to aid in injury healing, I'm just waiting on the compounds to be delivered.

At the moment I plan on running 1mg per day of each. Split into two shots, AM and PM, as advised on most forums. Any problems with drawing up BPC-157, then drawing TB-500 into the same syringe?

 

[mmaphd]

Go for it. I combine up to 3 peptides in a single syringe for injections sometimes.

 

[rastaman69]

My peptides arrived yesterday. I could not wait to reconstitute and get started!

As of this moment, I'm running 250mcg x2 dailyof BPC, and 2.5mg tb500 3 times a week. I'm pretty excited to see if this improves my injury. I have really high hopes and I hope I'm not let down. I thought the vacuum seal on the vial was pretty cool - the moment I pierced the vial with a syringe full of water it sucked all the water right into it! I didn't even touch the plunger.

I also had a talk with my girlfriend, I put a lot of stress on my upper body during sex so we're going to switch things up for a few weeks at least. Funny how sex drive will push away almost all physical pain for 30-40 minutes, then afterwards "fuck I shouldn't have done that" lol.

 

[That Guy]

I've not used these peptides before. I have become quite used to running multiple anabolic steroids at the same time and have a technique down for drawing multiple compounds into one syringe.

Care to share? I'm hoping your technique is better than mine.

 

[rastaman69]

Care to share? I'm hoping your technique is better than mine.

It's super easy. I use a big needle for drawing oils to make it faster. I start with whichever compound has the highest volume, because the first draw is the only one you can push air into the vial with. This way, I'm fighting vacuum less with the next draw. After everything is drawn up, I pull the plunger down a little to empty the needle (1ml syringes can go a little further than 1ml). Then install the fresh and sharp injection needle, push plunger until a tiny drop appears, and inject.

 

[dick_starbuck]

It's super easy. I use a big needle for drawing oils to make it faster. I start with whichever compound has the highest volume, because the first draw is the only one you can push air into the vial with. This way, I'm fighting vacuum less with the next draw. After everything is drawn up, I pull the plunger down a little to empty the needle (1ml syringes can go a little further than 1ml). Then install the fresh and sharp injection needle, push plunger until a tiny drop appears, and inject.

You can push air into the vial with all of the draws.

Before you draw from the next vial, draw some air into the syringe in the volume you'll be drawing from the next vial. Then penatrate the next vial, and push the air in until the oil in the syringe reaches the top of the syringe. Then draw whatever volume necessary.

Worse case scenario you push a little test in your npp, or some primo into your tren or whatever. It's all going to the same place anyway, it doesn't really matter.