DHT Blend question

[devildolphin]

To preface I have absolutely zero experience with home brewing. I understand basic recipes, procedures, equipment and whatnot. But have never brewed. So my question is:

How difficult would a blend of Mast E/1-Test Cyp/Primo E be to make. All dosed at 100 mg/ml for a total of 300mg/ml?

What super solvents etc. would you be likely to use to have it hold in solution.

Again. Not brewing, nor is anyone I know. I’m just genuinely curious. I think it would be an awesome blend to have around.

 

[MutantLabs]

Let me preface this by saying I have no kbowledge of 1-Test Cyp. But in my experience it shouldn’t be too difficult given that mast e and primo e are easy to brew if 1-Test Cyp is normally brewed at 100mg/ml. You might have to bump your BB up to 25% or so.

 

[Synergy Forge]

That’s going to be a tricky one. DHB (aka 1-Test Cyp) takes a substantial amount of chemicals to hold at moderate levels, the Masteron and Primo Depot are not as needy, but according to my calculations you would need 32.45% Benzyl Benzoate without a supersolvent, which would be extremely painful. If you introduced guaiacol to the compound you could use a formula such as 15% Benzyl Benzoate and 10% Guaiacol. That is calculated based on the solute being suspended in Fractionated Coconut oil with 2% BA. You would be able to lower those numbers further if you chose to use EO as the carrier; however I didn’t run that scenario.

Keep in mind that DHB carries a bit of a punch at 100mg/ml and the Primo is no slouch either but the Masteron appears to have some analgesic effects on the other 2 compounds which I am currently researching. So chances are this would be a fairly Pippy product but would be worse without the Masteron. Hope that helps,
Syn

 

[devildolphin]

Synergy Forge" pid='97229' dateline='1598507333:

That’s going to be a tricky one. DHB (aka 1-Test Cyp) takes a substantial amount of chemicals to hold at moderate levels, the Masteron and Primo Depot are not as needy, but according to my calculations you would need 32.45% Benzyl Benzoate without a supersolvent, which would be extremely painful. If you introduced guaiacol to the compound you could use a formula such as 15% Benzyl Benzoate and 10% Guaiacol. That is calculated based on the solute being suspended in Fractionated Coconut oil with 2% BA. You would be able to lower those numbers further if you chose to use EO as the carrier; however I didn’t run that scenario.

Keep in mind that DHB carries a bit of a punch at 100mg/ml and the Primo is no slouch either but the Masteron appears to have some analgesic effects on the other 2 compounds which I am currently researching. So chances are this would be a fairly Pippy product but would be worse without the Masteron. Hope that helps,
Syn

Okay. You drive a hard bargain. I’ll be your guinea pig.

No but seriously thank you for the detailed response. Is this something that you think yourself or other sources might be inclined to produce? Or is it too much of a hassle to really be worth it?

---

MutantLabs" pid='97143' dateline='1598402924:

Let me preface this by saying I have no kbowledge of 1-Test Cyp. But in my experience it shouldn’t be too difficult given that mast e and primo e are easy to brew if 1-Test Cyp is normally brewed at 100mg/ml. You might have to bump your BB up to 25% or so.

Thank your for the write up big fella. It always peaks my interest when it comes to niche blends and compounds.