Homebrew product missing a lot of mL

[UnderTheBridge]

So far out of both my Homebrew attempts my Test-E 250/mg final product of 100mL ended up missing a vial or two. My Tren-A at 100mL ended up two vials short. I’m following instructions, what am I doing wrong to be missing this much?

I weigh out powder, put MCT in graduated cylinder, withdraw BB and BA with syringe.

 

[Niceguy19]

Waste in the filters.

Full stop.

Figure 7-9% waste on all brews as a rule of thumb, unless you have professional setup.

 

[UnderTheBridge]

Niceguy19" pid='49756' dateline='1555883985:

Waste in the filters.

Full stop.

Figure 7-9% waste on all brews as a rule of thumb, unless you have professional setup.

Thanks <3 didn’t expect the loss to be that high.

 

[system]

7-9% loss of 100mL is still less than 1 bottle. Are you heating too much? Also, the surface of your containers will retain quite a bit of oil too. I’ve never done this but you could set aside a small percentage amount of MCT to pour into the filter after all the brewed stuff has passed through in the hopes of flushing out the rest of the compound if it is in fact stuck in the filter.

 

[UnderTheBridge]

musashi85" pid='49763' dateline='1555890151:

7-9% loss of 100mL is still less than 1 bottle. Are you heating too much? Also, the surface of your containers will retain quite a bit of oil too. I’ve never done this but you could set aside a small percentage amount of MCT to pour into the filter after all the brewed stuff has passed through in the hopes of flushing out the rest of the compound if it is in fact stuck in the filter.

Barely use any heat. Just warm setting on the hot plate.