Injection site on my ass oily

[maxwest525]

Been injecting 2mg of primo in glute .8mg of test in other glute. Was doing all in one syringe but switched to break it up. Recently changed from gso to mct on the primo. Around the site, after injection seems to get oily now like it is seeping through my skin. Is it the carrier oil? the volume of oil? Am I losing my dose?

 

[thallandchill]

How long are the needles you are using and what gage?

 

[propionate]

2mg? That’s not a lot of primo

 

[Beetlejuice]

Sounds like your syringe is leaking. I’m assuming you mean ml so is it .2 ml of primo? Are you using a skin pin or a needle that’s not luer lock?

 

[maxwest525]

2ml my bad. and 23 gauge 1 inch. bd luer lock off gpzmedlab

 

[blvck.scvle]

I feel like I’ve had this happen before when I first started pinning, I assumed it was because I was pulling the pin out with a very small amount of oil still left in the syringe. I started holding the plunger down for a few seconds after the syringe is empty, I don’t know if that was the cause but haven’t had the issue again though.

 

[superawesomename]

maxwest525" pid='63577' dateline='1564795398:

2ml my bad. and 23 gauge 1 inch. bd luer lock off gpzmedlab

Are you fully driving the needle? I use 1.25s for quads and if I don’t fully drive the needle I can sometimes get a little leak.

 

[Jacked]

Stop. Coring. Your. Ass.

 

[yelruP]

Jacked" pid='64033' dateline='1565133680:

Stop. Coring. Your. Ass.

I core my hip bone instead