Has anyone had issues with test cyp forming crystals? When I first received my order from here it had got to cold and was crystallized and I tried putting it in warm water but it doesn't seem to wanna mix back into the solution.
It's not uncommon, and sometimes it can be a bit stubborn getting the crystals to dissolve, and you likely just need higher temp for longer. You can take a skillet/saucepan and fill it with a half inch of water and place the vial in that. Heat close to a boil and let it sit for 5-10 min. I often take it out after heating for a few and shake like crazy then put it back in, especially if crystals are stuck up near the top by the stopper from being on its side during transit. Just takes a bit of work sometimes.Has anyone had issues with test cyp forming crystals? When I first received my order from here it had got to cold and was crystallized and I tried putting it in warm water but it doesn't seem to wanna mix back into the solution.
Thanks for the advice, I'll try it.It's not uncommon, and sometimes it can be a bit stubborn getting the crystals to dissolve, and you likely just need higher temp for longer. You can take a skillet/saucepan and fill it with a half inch of water and place the vial in that. Heat close to a boil and let it sit for 5-10 min. I often take it out after heating for a few and shake like crazy then put it back in, especially if crystals are stuck up near the top by the stopper from being on its side during transit. Just takes a bit of work sometimes.
My TSH is good but I have gotten bloodwork 2 times on the end of a cut and both times, my TSH is pushing 3 as I get lean. When I’m at a comfy bf (13-15%), it’s at 1.6.is your tsh level fine too? Did they test t4 to t3 conversion enzymes? reason I'm asking is that your body senses when it needs t3 so it converts t4 to it. If your t4 levels are fine, then t3 probably isn't your issue and will just eat up your muscle too.
You can also try using a baby wipe warmer. Somebody else mentioned it on another thread. I picked one up from Amazon, put it on low setting which is around 90 degrees and un-crashed some DHB with it. Now I just keep everything I’m currently using in it, it’s way easier to draw when it’s warmHas anyone had issues with test cyp forming crystals? When I first received my order from here it had got to cold and was crystallized and I tried putting it in warm water but it doesn't seem to wanna mix back into the solution.
Thanks, ill try that.You can also try using a baby wipe warmer. Somebody else mentioned it on another thread. I picked one up from Amazon, put it on low setting which is around 90 degrees and un-crashed some DHB with it. Now I just keep everything I’m currently using in it, it’s way easier to draw when it’s warm
5+ years brotherHow long have you been using this source. Looking for a solid source with no pip and gso. I see you said this is the only place you order from
Have you taken other brands of t3 before to know how to compare?T3 so far seems legit. Just using 25 mcg and after a couple days, my basal body temp has gone from 196.4 (hypothyroid) to 197.4. Resting heart rate has gone from the 40s/50s to 75/80. It honestly kind of freaked me the fuck out. Especially on the second day my damn heart rate in the morning reached 102 BPM lol. And I’m a guy with a very low natural heart rate.
They use GSO.@LockandLoadLabs Carrier oil for the Test E 250mg/mL?
How about an emailI'm order 3939 when can I expect shipment
ent emailHow about an email
Same thing happened to me but gear showed up on 5th day@LockandLoadLabs I paid already. it's been 4 days with no answer to my emails or no tracking even though it they said products were in stock and they said items were being shipped same day