Whats going on guys, well after a unseen vacation (6+months)lol, I came back and decided I was gonna brew from now on, cost wise makes soo much sense. Did a little trial run with Test P usinn 2/20% BA/BB in gso 40ml’s worth at 100mg, anyways I waited to brew the rest of my raws till I got my vials caps etc… so I brewed a batch of tren A 100ml of 100mg/ml in Miglyol840 using 1.5/15% BA/BB, of course like a little kid I couldn’t wait and did it as fast as possible, I had all of the other vials sealed in a container and 1 to use immediately( I was waiting for crimper in the mail) now out of the 10 vials the 1 I used when i looked the next morning, it seems as if moisture might have gotten in(like little bubbles that would settle on bottom) its been 3 days since, the 9 other are sealed golden yellow and great, of course not being able to leave the vial I was using with the bubbles I proceeded to read on possibly baking it using a needle as a vent… so I placed the vented vial in the oven at 250f for 10 mins. periodically when I opened the door to look, it seemed as if the bubbles were rising to the top and evaporating. It came out crystal clear, same color etc. I placed the vial in the cabinet and when I went to check on it and to relieve any pressure build up from cooling… it was completely cloudy? WTF, ran it under hot sink water became crystal clear then back to cloudy 1 min after removing from the water… now my question is
- WTH happened? is this vial fucked?
- I started thinking about how I brewed it and that being I placed the BA and BB in the Beaker added tren raws then the Migylol and placed it into almost boiling water inside a pot, I let it sit, stirring occasionally till it was crystal clear, technically doesn’t that mean that everything went smoothly once it turns clear? how long roughly do you really need to keep it on once its crystal clear? and I know I shouldn’t have been cheap and skip out on the hotplate & thermometer, I guess that’s what I get for rushing. Is my Gear still good?
- got the rest of test P and Test E to make and I don’t really feel like making the same mistake twice, also anybody have any experience with miglyol840 and what concentrates of Ba/BB to use for test p and test e, I probably could have used less than 15% BB on the tren in Mig but it was the one raw I was gonna be using personally, didn’t really have time for the trial and error or experimenting either, also couldn’t wait to start lol
- Last one was even tho the miglyol came from medlab, should I boil the oil before I use it? Came across it while reading but its not mentioned much, Also yes everything was ran through a .22 fliter
Last edited: